濟南防水公司http://www.tianyujian.com/分析水池涂膜防水層起鼓主要是基層質量差，基層混凝土或砂漿有起皮、開裂、起粉等缺陷影響粘結，基層潮濕，粘結不良，水分蒸發產生的壓力使涂膜起鼓；水池中濕度大，有的通風不良，施工環境差，在涂層面常有冷凝水，沒有擦干就施工上層涂料，將冷凝水裹在其中，冷凝水受熱汽化使上層涂膜起鼓，防水涂膜起鼓就破壞了防水層的連續性、整體性，容易破損，使水滲漏有通道。
Jinan waterproofing company analysis pond waterproof coating layer from the drum major is poor quality grass, grass concrete or mortar from the skin, crack, powder defects affect the bond, grass-roots moist, poor adhesion, water
evaporation pressure generated by the coating play drums; pool humidity, poor ventilation and some construction environment is poor, the coating surface often condensed water, no paint dry on top of construction, which will be wrapped in the condensed water, condensed water from the heat of vaporization of the upper layer coating drums, waterproof coating from the drum to undermine the continuity of the waterproof layer, holistic, easily damaged, so that the water leakage have access.
濟南防水公司談到將起鼓部分劃開、全部割除，露出基層后檢查，如基層有孔隙或酥松之處，則先要修補基層和堵塞基層上的孔隙。待基層干燥后，涂基層處理劑封密基層的水分，再依防水層的規定逐層抹涂，必須待上層硬化后，經檢查無空鼓脫殼方可施工下一道涂層。修補平整后再擴大面積，加做一層增強涂布層。
Speaking Jinan waterproofing company will play a drum part gash, all cut off, exposing the grass after the inspection, such as grass-roots level have voids or crisp Department, the first to repair the grassroots and the grassroots on the clogged pores. After drying grass, painted primary treatment agent sealed grassroots water, and then step by step in accordance with the provisions of the waterproof layer trowel, you must wait until after the upper sclerosis, after checking without hollowing shelling before construction under a coat. Patch formation and then expand the area, a plus enhancement layer coating layer.
濟南防水公司http://www.tianyujian.com/介紹涂膜防水層的收頭處或細部周邊處出現同基層剝離翹邊現象，主要是基層沒有處理好。不清潔、不干燥；基層處理劑沒有涂布好，底層防水涂膜附著力低，細部收頭操作不細致。
Jinan waterproofing company presentation appears with grass-roots phenomenon stripped Alice detail close head office or at the periphery of waterproof coating layer is mainly grass no deal. Dirty, not dry; primary treatment agent is not
coated, low underlying waterproof coating adhesion, detail close the first operation is not detailed.